NX-200 Zone doubling kit (includes one hundred 3.74k and one hundred 6.98k resistors). NX-148E-RF Alphanumeric 48-zone LCD keypad with built-in 48-zone wireless receiver. What kind of control panel does nx-148e have? LED keypad programming 11 Control panel programming 14 Programming locations 19 Chapter 3 Troubleshooting 53 General diagnosis 54 Trouble conditions 54 Voltage tables 56 Specification 57 Appendix A Reporting codes 59 The armed and exit lights will illuminate.Enter your 4 or 6 digit user code to arm the system.The security system will not arm if the ready light is not on or flashing.Ready light will be on or flashing when all protected zones and sensors are secure.Resetting Smoke Detectors To Reset smoke detectors: Press and hold until keypad beeps. If your battery is low, it will either need to be disconnected or replaced. When the battery is low or dead in an old alarm system, the system will start beeping to alert you that it needs to be replaced. Most alarm systems have a backup battery that kicks in if the power ever goes out. When finished, press the key to return to the code entry system. To bypass or unbypass a specific zone, press the key while that zone is displayed. At this point, your keypad should stay silent and your alarm memory should reset. After completing this step, press the “asterisk” key (*) followed by the “7” key. To reset your alarm’s memory, first disarm your system if it is currently armed. Press the key again to exit group bypassing. Press the ‘Exit’ key to return to main screen.īy pressing the key, followed by the key, then the key again, all zones that are designated as group bypass zones will be bypassed.When it asks for ‘Device Address’ enter 0 followed by #.If this is not a new panel then you will need to default the panel programming back to factory default by doing the following:

Networx alarm system reset code